Attaching the Steel Wire Coil to the Binding Posts

 

Attach one of two wire coil leads to the hole on the right side of one of the two binding posts, as shown.  Be sure to insert the coil lead until it touches the back of the post (note the contact points).  Then tighten the post to secure the lead. Repeat this procedure for the second lead.

 

IMPORTANT!   Each lead must touch the back of the post to ensure the correct length of insertion. Note the red arrows in Figure 14.

 

 

 

Figure 14 - Attaching wire coil to binding posts

 

 

Figure 15 – Close up of binding posts

 

Once the wire coil is secured to the binding posts, close the protective cover on the CAT-100.

 

Note: The CAT 100 coils are not compatible with carbonitriding processes.

 

IMPORTANT! Ensure that the wire coil does not make contact with the external thermistor once the wire is attached to the binding posts. The location of the external thermistor is noted in Figure 14